LO206 Carb Tuning for GCKI

Forum for LO206 & Chonda classes

Moderators: Brian Traw, Mike Hewitt, Tom Dunlap, Rick Miller, Scott Boone

Post Reply
Ryan Van Winkle
Posts: 7
Joined: Sun Oct 22, 2017 8:30 pm

LO206 Carb Tuning for GCKI

Post by Ryan Van Winkle » Tue Oct 09, 2018 12:19 pm

Howdy guys,

I'm curious as to a general carb tuning starting point for everyone running the LO206 at GCKI. I've found the following guidelines online, and am curious if this holds pretty true for our typically higher humidity and low altitude:

Float height = .860 / .880 inch
Float drop = 1.050 inch
Idle air bleed screw = 1-2 turns out
C- clip needle setting = middle slot ( #3 slot )

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest