Safety Wire Washers?

Questions and comments re engines, kart setup, gearing and related topics

Moderators: Brian Traw, Mike Hewitt, John Bartos, Rick Miller

Post Reply
Dan Honovich
Posts: 16
Joined: Mon Aug 02, 2010 7:27 pm

Safety Wire Washers?

Post by Dan Honovich » Fri Sep 17, 2010 7:47 pm

http://www.solomotoparts.com/product.ph ... 531&page=1

I came across these on the internet and didn't know if its something that would pass inspection or not. Thought it was a neat idea.

Rick Miller
The master poster
Posts: 134
Joined: Tue Sep 04, 2007 8:49 am

Re: Safety Wire Washers?

Post by Rick Miller » Sat Sep 18, 2010 7:09 am

I have not seen these type fasteners yet. Most karts have special bolts with grooves machined on the stem of the bolt to accomodate a c clip type fastener ie: kingpin bolts,caliper bolts. On weights, double nutting is allowed at GCKI unless you are running under RMAX Challege rules, the bolts must be drilled and safety wired. Taking the extra time to drill bolts is time well spent.

Brad Johnson
The master poster
Posts: 335
Joined: Wed Aug 08, 2007 1:59 pm
Location: Magnolia, Texas

Re: Safety Wire Washers?

Post by Brad Johnson » Tue Sep 21, 2010 10:55 am

Little but like the washer that holds the clutch basket nut in a CR125. Tighten the nut and bend up one of the tabs to hold it in place.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest